Pump Jet Propulsors for Vanguard and Trafalgar Models
Hand built, one piece castings, supplied complete with prop shaft in stainless steel.
This 5-bladed prop is true to scale for the Nacken model. It is about 4-1/2 in (115 mm) in diameter.
The scale prop for the
Upholder features seven blades, like the real thing. These subs were rumored
to be retrofitted with pump jets, but the status of this is uncertain since
their acquisition by the Canadian Defence Forces. It is 3-3/4 in (95 mm)
diameter.
Also candidates for pump
jet retrofits, the original Trafalgar featured the carefully shaped 7 bladed
prop shown here. It is true to scale with a diameter of about 3 in (76 mm).
This unusual 'petal'
bladed prop was used on the Type 205. It measures some 2 in (51 mm) in
diameter.
Used on the German Type
23 coastal sub, this conventional 3-bladed prop measures some 1-3/4 in (95
mm) in diameter.
Contra-rotating prop pair for 1/9 scale torpedoes. Note that there are two props, each
with two blades; one is 'left handed' and the other 'right handed.' They are
about 1-1/2 in (38 mm) diameter.
This is the prop used on the Molch and Seehund torpedoes.
We also supply a selection of propellers and pump jet castings which are available for our entire range of submarine models